|
Join Our Sponsored Forums |
||||||||
|
|
|||||||
|
Nitrate Reactor Recharge Dissolve Approximately 50gm of salt in 2 litres of water. Arrange a simple, small bore siphon system from this salt solution to allow water to run through the unit awaiting re-charge, at a maximum flow rate of 0.25 litre per minute. (The slower the flow the greater the contact time given and therefore the better regeneration gained). Whist re-charging the system the unit should be mounted or stood vertically and the salt solution should be flowing against the normal usage flow direction. Following completion of salt regeneration a clear water flow should (again backwashing against the normal flow at 0.25ltr/min for 30 min). After the 30 minutes, a fast flush for just 2 minutes maximum will re-establish the media bed and leave the unit ready for re-use.
|
||||||||
|
All information on this site is provided by the webmaster and, should there be a pricing error, it is my fault and not the shop or its staff. Any prices marked on stock shown on these pages were correct at the time the image was taken. If you have a question regarding the site Click to email me Erdington Aquatics 97-99 Church Road Erdington Birmingham B24 9BE England Telephone: 0121 373 1100 |
||||||||
|
© aquatic-store.co.uk |
||||||||
